ok I finally got my Inzer belt, see here: belt_13mm_lever_xlrg.jpg
some minor assembly required, it came with 2 screws, buckle, & back plate for buckle I guess.
vague, sketchy written directions, no drawing or diagram.
not clear to me how this buckle is supposed to go on? any help please? appreciated.
Last edited by Rugby Dad; 06-12-2010 at 02:01 AM.
The plate goes on the inside of the belt. Screws through the plate from the inside, lever on the outside (obviously) with prongs facing towards holed end of belt. You will probably have to try a few placements before you get it how you want it.
Got this from sherdog forums, hopefully it'll help. I have the single prong, best freaking belt ever!
Last edited by Mark!; 06-12-2010 at 02:25 AM.
242's by May
You basically put the screws through the plate and then they screw into the actual lever mechanism. The latch should open toward the open end of the belt. You clip the lever mechanism into the two holes on the other side of the belt and then pull it closed to tighten the belt. Do not tighten the screws too much when you are sizing it since chances are you will probably have to adjust it 1-2 times to get it right.
thanks for the help guys.
I got it assempled now.
last question, how tight do most of you wear your belt?
Shoulda' got the dbl. prong forever belt bro... Just kidding.
I'm gonna get me a lever soon since I tried one of my buddys at the gym... I liked it a lot but changing the screws could present a problem since I wear my belt different for sqauts & Deadlifts.
What is your experiance w/ changing the lever belt sizing Tom?
it's actually pretty easy adjusting the holes. I used a penny to work the screws.
granted in between pulls and squats it's gonna be a pain in the ass.